PRODUCTS FEATURES:

    Range: 0~9990us/cm
    Resolution: 1us/cm(0~999us/cm) 10 us/cm(1000~9990us/cm)
    Accuracy: ±2% Full Scale
    Calibration: Factory Calibrated
    Auto shut-off: 10 minutes
    Temperature Compensation: Automatic
    Operating Temperature: 0°C to 50°C
    Power source: 2×1.5v (button cell)
    size: 142X 25X15mm
    weight: 36g
    

OPERATING INSTRUCTIONS:
    1. Remove the protective cap.
    2. Press the ON/OFF button once out of the water. The tester will read "000".
    3. Immerse the tester into the water no more than 2 inches.
    4. Wait for the display to stabilize. The tester automatically compensates for temperatures variations. Once the readout stabilizes (10-30seconds), press the HOLD button to view out of the water.
    5. Press the ON/OFF button again to turn off the tester. The tester will shut off automatically after 10 minutes of non-use.
    6. After usage, shake off the water from your tester or wipe it with a tissue.
    Note: If the tester displays a flashing"X10"icon, multiply the reading by 10.
    Important: Do not drop the entire tester in the water or dip beyond the maximum 2” level. This product is not waterproof. Tester is not meant to be used in hot water.
    Calibration: your meter has been factory calibrated to 500us/cm, which is suitable for most applications. Re-calibration may be necessary from time-to time, depending on usage.
    Maintenance:
    A:If the meter cannot be switched on or the display fades, please replace the batteries. Please pay attention to the polarity of battery.
    B:If pin electrode is dirty, clean by rinsing it in alcohol for 1 minute.
    C:Do not touch or scratch the pin electrode.